x
uploads/spot welding.jpg

spot welding 點焊。

spot-check

Electrode taper fits for spot welding equipment ; dimensions ; identical with iso 1089 , edition 1980 點焊設備的電極錐度配合.尺寸

Series spot welding 單邊多點點焊

Situation and expectation on the surface treatment of resistance spot welding electrodes 電阻點焊電極表面處理的研究現狀和展望

Specification for resistance spot welding - electrode holders - morse taper fixing 點焊設備規程.電極夾具.第2部分:莫氏錐形接頭

Influence of deep cryogenic treatment on electrodes wear for aluminum alloy spot welding 深冷處理對鋁合金點焊電極燒損的影響

The joint shall be used spot welding with 10spots as per configuration below 這個接合處將被使用在每10個結構點下的焊接處。

Resistance welding equipment - angles for mounting spot welding electrodes iso 12145 : 1998 電阻焊接設備.點焊電極的安裝角度

Effect of cryogenic treatment electrode on spot welding quality for galvanized sheet 電極深冷處理對鍍鋅鋼板點焊質量的影響

Specification for resistance spot welding of uncoated and coated low carbon steel 有鍍層和無鍍層低碳鋼電阻點焊規范

Spot welding ; electrode back - up and clamps ; identical with iso 5827 : 1983 status as of 1985 點焊.電極擋塊和夾緊裝置

Study on deep cryogenic treatment electrode life for spot welding aluminum alloy 深冷處理的鋁合金點焊電極壽命研究

Resistance spot welding . electrode holders . part 1 : tapper fixing 1 : 10 電阻點焊.電極夾頭.第1部分:固定錐度為1 : 10

Hdpe plane spot welding bag 低壓聚乙烯服裝袋。

Railway rolling stock - spot welded joints of mild steel - design methods 鐵路車輛.低碳鋼點焊焊接接頭.設計方法

Resistance spot welding . electrode holders . part 2 : morse taper fixing 電阻點焊.電極夾頭.第2部分:莫氏錐度固定

Resistance spot welding - electrode holders part 2 : morse taper fixing 電阻點焊? ?電極握桿第2部分:莫氏錐度配合

Control system design of soft - switch spot welding inverter base on dsp 的軟開關點焊逆變電源控制系統硬件設計

Optimal spot welding parameters selection for automobile steel plate 汽車用鋼板電阻點焊工藝參數優化選擇方法

Recommended practice for automotiv weld quality - resistance spot welding 汽車焊接質量的推薦規程.電阻點焊